Mass Production QC

Course curriculum

1. Department Workflow
2. Inspection Basics-How to Read a Drawing
1. What is a Blade Micrometer?
2. Using a Blade Mic on an Abutment Blank
3. Using a Blade Mic on a Screw
4. Using a Blade Mic on an Analog
5. Using a Blade Mic on a Scan Body
1. What is a Micrometer?
2. Using a Micrometer on an Abutment Blank
3. Using a Micrometer on a Screw
4. Using a Micrometer on an Analog
5. Using a Micrometer on a Scan Body
1. What is a Digital Height Gauge and what are Pin Gauges?
2. Using a Digital Height Gauge on a Scan Body
3. Using Pin Gauges on a Scan Body
1. What are Digital Calipers?
2. How to Use Digital Calipers on an Abutment Blank
1. An Explanation of Ring Gauges and How to Use them on a Screw
1. An Explanation of Thread Gauges and How to Use them on an Abutment Blank
1. An Introduction to the Microscope
2. Adjusting the Camera and the Lighting on the Microscope
3. Using the Microscope to Measure a Part
1. An Introduction to the Hommel
1. An Introduction to the Keyence
1. Inspecting an Abutment: Part 1
2. Inspecting an Abutment: Part 2
3. Inspecting an Abutment: Part 3
1. Inspecting a Scan Body: Part 1
2. Inspecting a Scan Body: Part 2
3. Inspecting a Scan Body: Part 3
1. Inspecting a Screw: Part 1
2. Inspecting a Screw: Part 2
3. Inspecting a Screw: Part 3
1. Inspecting an Analog: Part 1
2. Inspecting an Analog: Part 2
1. Mass Production QC Part 1 Exam
2. Mass Production QC Part 2 Exam

Enroll today